Ncam

LightAct supports both TCP and UDP versions of this protocol. User also needs to enter the Server address, which is the IP address of Ncam running server.

Ncam Receiver Device Node

To start receiving Ncam information insert a Ncam Receiver device.

On the right side, under the Stream, configurable properties for specific devices will be shown. After you configure them, check Listen checkbox inside the device node.

Read Ncam in Layer Layouts

To use the information read by Ncam Receiver node in LightAct, you need to create a Read Ncam node in the layouts.

Choose Ncam Receiver device in a Device dropdown menu, or connect Device reference node to this input, and you are ready to go.